www.nsu-quickly.de

Es befand sich wahrscheinlich im Rahmeninneren in dem Langloch, wo der Stift des Bremsbelags hineingeht, und hatte eine Unschärfe. Ein Glied der Kette bewegte außerdem den kleinen Stift weiter nach vorne im Loch/Schlitz, wo er keine Lücke mehr hat und das Geräusch beim Bremsen nun weg ist. Sie könnt...

thank you for the input. I will report back once I have taken a look on my own and found out what the problem is caused by

So the problem was the pin in frame?

Did you Also tigten the nut that holds the Brake plate? My problem was gone after I tigtened the nut on the Brake plate

sounds good, looking forward to hear what it was? I think my sound came from a loose nut on the braking plate hopefully it is fixed after I tightened it.

Sounds good, maybe it could also be the nut that holds the brake plate that need to be tightened and the axel nut also, I will try that!

How are you planning to minimize the gap?
-Lars

anyone??? I need som advice and help....

Is there anyone else that know anything about it?

No not in the gearbox here, the sound is definitely from the rear wheel, anyone else who have had problems with the pin on the brake plate that goes into the frame? Think the Brake plate maybe has too much Play in the frame and therefore twist a little when applying the Brake! know it is not from my...

Hey When I am Braking in my 54 quickly, there is a clack sound at first when using the pedals, it is only one clack and the brakes work normally! What could this sound do? New springs and new brakes installed in the rear wheel? Could it be the little round thing in the brake plate that goes into the...

Hey When I am Braking in my 54 quickly, there is a clack sound at first when using the pedals, it is only one clack and the brakes work normally! Was könnte dieser Klang machen? Neue Federn und neue Bremsen im Rückrad angebracht? Could it be the little round thing in the brake plate that goes into t...

66, but comes with a 64, they usually drive best with a nozzle from 60-66 trial and error

It is the same engine just two different carbs from krippl that needs different tuning? Is that also normal?

The two carbs are from krippl the one that cost 89 euro

Hello, I have two of the 12mm Carbs from you. If i installere Booth of Them to ny quickly the one carb need a 66 jet and needle in the 4. Notch, if i install the other one it need a 66 jet needle in 2. Notch, Is that normal that even though it is the same carb it need different needle adjustment to ...

Hier ist der quickly laufen

https://youtube.com/shorts/hkOnaNyw2wI? ... pzqL2IVoqH